These Environmental Test Chambers can satisfy a variety of environmental conditions. They are especially suitable for the simulation of fixed temperature and relative humidity valves above freezing point. Used for seed testing, biological studies, forestry research work etc.
After stabilization high temperature and humidity accuracies are obtained . The chambers are widely used for testing of electronic and electrical components, corrosion test on mechanical assemblies, tests on packages, paints & varnishes, cement plants & variety of other applications.
Constructed of double walls, the exterior is made of sheet steel, the interior of stainless steel. A flush fitting insulated door has leak proof gasket. The shelf position of trays is adjustable.
The rear chamber of the interior is fitted with a refrigeration evaporator , heater and powerful air circulating fan to create a positive air flow through the chamber. A hermetically sealed compressor below the chamber provides temperatures below ambient. The same compartment houses a boiler with an immersion heater and water level controller for creating humidity.
Safety Thermostat to prevent over – heating. Audio- Visual alarm for low water level with cut out.
The control panel comprises of ON/OFF switches, heat energy regulators, fully automatic Microprocessor based Temp. Indicator & Humidity Indicator-cum-controller (Direct display of Humidity in % RH) , indicating lamps and protective fuses.
Temperature Range 10˚C to 60˚C
Accuracy ± 0.5˚C
Humidity Range 45% to 95% RH
Accuracy ± 3% RH
Specification subject to change without notice